L
After releasing the handle-bar, it will be vertical automatically.
et the handle-bar be vertical, the driving motor is stopped mechanically.
After parking of the truck, the electromagnetic braking takes the function of park braking.
Reversing current braking
In case of control system or driving power malfunction, it is possible to use reverse braking.
Rotate
the
FWD-BWD Tuning Knob
against the direction of driving until the truck is stopped.
Then release the
FWD-BWD Tuning Knob
.
Inertia braking
After releasing the
FWD-BWD Tuning Knob
, it returns back to “0” position and the truck is
stopped by motor inertia. Noting that the ratio of speed reduction is subject to the position of
the
FWD-BWD Tuning Knob
.
If inertia braking is removed by maintenance staff and the
FWD-BWD Tuning Knob
is set at
“0” position, the truck can be stopped only by electromagnetic braking and reverse current braking.
4.3.2 Operation of cargo loading/unloading
Before loading the cargo, the operator must check to confirm the cargo is properly placed on
the pallet and the weight of cargo within the load capacity of the truck. Remember that carrying a
cargo in full load for a long time is prohibited.
The forks should extend to the bottom of the cargo completely.
Let the control handle(217) be
Raise or Lower
position when you want to lift or lower the
cargo.
Lifting of forks
Let the control handle(217) be
Raise
position, then move the handle-bar up and down.
Lowering of forks
Let the control handle(217) be
Lower
position, the fork will be down automatically.
12