5
INSTALLATION
1.
Attach the antenna to wall
or any other non-metallic
surface using the provided thumbtacks or temporary
masking tape.
a.
Ensure that the antenna is unobstructed (not
behind anything) and as high as possible. You can
attempt to conceal your antenna after you have
confirmed it is working.
b.
The antenna should be generally pointing in the
direction provided by the report obtained by
entering your address into
NoCable.org
2.
Connect either end of the coaxial cable
to the bottom
of the antenna.
6
3.
Attach the open end of the coaxial cable to the
connecter located on the amplifier.
Connect the
coaxial cable attached to the amplifier to the ANT/IN
port on the back of the TV.
4.
Connect the amplifier to a power source.
You can use
the USB port on your TV (4b), or the provided power
adapter when plugged into any standard wall outlet
(4a). The light on the amp will be red if working
properly.
5.
Scan for channels.
In the TV’s setup menu, set the
signal type to “Broadcast”, “Antenna” or “Air” (NOT
CABLE), then set the TV to “Scan” or “Program” for
new channels. Consult your TV’s manual for detailed
instructions.
6.
Adjust antenna for best reception.
Try various
positions, heights and directions to gain better
reception. Perform a channel rescan after each
adjustment.
7.
Secure antenna permanently.
Once optimal reception
has been found, permanently secure the with the
provided thumbtacks or double-sided adhesive.
Still having issues?
Continue on to our troubleshooting tips…
