Interface
1.
Power LED
Illuminates White when unit is «On». Will illuminate orange after the 60-second timeout countdown until the clamps are removed from
the Car Battery or the GBX155 is power cycled ‘off’ and back ‘on’ again.
2.
Power Button
Push to turn unit «on» & «off» or restart boost after 60-second timeout.
3.
Reverse Polarity Error LED
Illuminates red if reverse polarity is detected.
4.
Cold LED
Illuminates solid or flashes blue when internal temperature is too low.
5.
Hot LED
Illuminates solid or flashes red when internal temperature is too high.
6.
Error LED
Blinks “on” and “off” in various sequences (from 1 to 6 blinks) to convey error conditions.
7.
Internal Battery Level
Indicates the charge level of the internal battery.
8.
Light Mode Button
Toggles the ultra-bright LED light through 7 light modes: 100% > 50% > 10% > SOS > Blink > Strobe > Off
9. Boost LED
Illuminates white when boost is active. If the unit is connected properly to a battery, the GBX155 will automatically detect a battery and
go into boost mode (LED flashes white when manual override feature is active).
10. Manual Override Button
To enable, push and hold for three (3) seconds.
WARNING: Disables safety protection and manually forces
Boost «On». Only for use when a battery voltage is too low to be detected.
11. Fast Charge LED
Illuminates white when fast charge is active. Fast charge LED turns red (solid/blinking) when there is an error.
Summary of Contents for Boost X GBX155
Page 7: ...EN ...
Page 18: ......
Page 29: ......
Page 34: ...www no co support GBX155 10262020B For more information and support visit ...
