Spray jet pulsates
✔
The coating material in the
container is running low
✔
Refill the container with
more coating material
✔
The air filter soiled
✔
Clean or change the air
filter
✔
The feed tube has come
loose
✔
Reinsert the feed tube
again
✔
The feed tube is clogged
✔
Clean the feed tube with
the included brush
Material runs down the
object being painted
✔
Too much coating material
has been applied
✔
Reduce the material
volume
✔
The distance is too small
✔
Increase the distance
Excessive paint mist
(overspray)
✔
The distance to the object
is too large
✔
Reduce the distance to
the object
✔
Too much coating material
is being applied
✔
Reduce the material
volume
✔
The air pressure is too
high
✔
Reduce the air volume
✔
The coating substance is
over-diluted
✔
Reduce the degree of
dilution of the coating
material
✔
Incorrect spraying
technique
✔
See “How to get the best
results” on page 23
Paint in the ventilating
hole
✔
The seal is dirty
✔
Clean the seal
✔
The seal is defective
✔
Replace the seal
29