NOCTUA NH-U9S chromax.black
INSTALLATION MANUAL
Scan this code to display
multilingual manuals on
your phone.
Then put the heatsink onto the CPU and screw it to the screw
threads of the mounting bars. Perform 2-3 turns on each
screw, then repeat until both are fully tightened.
Caution: Gently tighten the screws until they stop, but don’t use
excessive force (max. torque 0.6 Nm).
Caution: Please first take off the fan as well as the protection
cover at the bottom side of the heatsink.
Fastening the heatsink to the CPU
4
Reattach the fan to the heatsink using the supplied steel clips:
Fan setup
5
!
Even with high-grade products and strict quality control, the
possibility of defects cannot be eliminated entirely. Therefore,
we aim at providing the highest possible level of reliability and
convenience by offering a warranty period of 6 years and
direct, fast and straightforward RMA service.
Should you encounter any problems with your NH-U9S
chromax.black, please don’t hesitate to contact our support
team (support@noctua.at).
Please also consult the FAQ section on our website:
www.noctua.at/faqs.
Warranty, support and FAQs
1.
2.
3.
Connect the fan to the motherboard’s CPU fan header.
Depending on your CPU and the temperature inside the
case, you may interconnect the supplied NA-RC7 Low-Noise
Adaptor (L.N.A.) in order to further reduce the fan’s operating
noise.
Caution: When using the L.N.A., check the temperature of
your CPU using appropriate software (e.g. the respective
applications of your motherboard manufacturer), in order to
evade automatic throttling of the CPU due to the increased
temperature. If the cooling performance is insufficient, please
increase case ventilation or remove the L.N.A..
Adding a second fan
The NH-U9S chromax.black includes an extra set of fan clips
for installing a second NF-A9 fan in push/pull mode in order
to further improve cooling performance.
