FUNCTION DISPLAY & RELATED BUTTONS
Manual Operational Mode
The manual operation will allow the fixture to be used in a conventional manner where
power to the fixture is manually switched ON for “stand alone” use. This is done by press-
ing the power switch/ circuit breaker to the ON position.
1) Plug the power cord into a power source and push the power switch/ circuit breaker to
the ON position.
2) The display will energize and show the TIMER mode - select ADDRESS mode by
depressing the FUNCTION SELECTION BUTTON (diamond). The display should read
“A” followed by three digits.
3) The fixture display is initially preset at the factory to the address “A000” when it arrives.
If this address is not displayed, press the NUMERIC SELECTION BUTTONS (triangles)
until the display reads “A000”. The relay within the fixture will close and the lamp will
ignite. Full lamp output is attained within 5 minutes.
NOTE: The NUMERIC SELECTION BUTTONS scroll with ascending numbers, from “0”
to “9” before recycling to “0”.
Function Selection Button
Display Window
Numeric Selection Buttons
DISPLAY WINDOW for MANUAL MODE (Sample Display)
10
