I.
INTRODUCTION
The NOCTURN UltraViolet Light Source is intended to provide a source of illumination for
fluorescent materials. The fixture can be used in a variety of applications where high inten-
sity fluorescent illumination is desirable, such as entertainment, special effects, industrial,
and scientific uses.
Caution/ Warning Statements
The following cautions and warnings apply to the use, maintenance and care of the UV
light source.
•
This operation manual should be read and fully understood to enhance operator safety.
•
Disconnect the power cord prior to attempting any servicing to the fixture. Always verify
the cord is unplugged prior to opening the front cover for lamp replacement or servicing
the fixture.
•••••
DO NOT OPERATE THE FIXTURE WITHOUT AN INTACT FILTER WINDOW
SECURELY IN PLACE. REPLACE THE WINDOW IF ANY CRACKS ARE FOUND
THAT MAY ALLOW UNFILTERED LIGHT TO ESCAPE.
•••••
THE LAMP PRODUCES INTENSE LEVELS OF ULTRAVIOLET RADIATION WHICH
WILL CAUSE BURNS OR DAMAGE TO BARE SKIN AND UNPROTECTED EYES.
DO NOT ALLOW THE FIXTURE TO OPERATE IN ANY MANNER THAT ALLOWS
UNFILTERED LIGHT TO BE RELEASED.
•
Adequate cooling is necessary for operation of the fixture. Provide a minimum of 6” free
air space on the sides and rear of the fixture. Do not place any combustible objects
closer than 24” in front of the fixture while it is operating. The fixture must not be oper-
ated in confined areas subject to ambient temperatures higher than specified (see
Section I, System Specifications).
•
Allow a minimum of 10 minutes for lamp cooling before attempting to replace the lamp.
Portions of the lamp attain extremely high temperatures during operation and can
cause serious burns if touched while hot.
•
Do not subject the fixture to extreme mechanical shock or rough handling that may
damage the lamp or internal fixture components.
•
For maximum lamp life, allow the lamp to remain ON for a minimum of 5 minutes any
time the lamp is ignited.
•
Clean the lamp with isopropyl alcohol and a lint-free cloth after it has been installed into
the fixture to help eliminate premature failure from contaminants. This procedure will
help increase life and performance.
•
When removing a fixture for servicing or inspection, exercise extreme caution when
loosening the clamp from the pipe or truss. The fixture may be installed in such a man-
ner that a moment arm is created during the installation. This may cause the fixture to
swing down violently when the clamp is loosened.
3
