3. Pair the second phone to the N620 using the
pairing instructions above.
phone.
5. Select “NoiseHush N620” on your phone list of
Both phones are now paired to the N620.
Using the Multipoint feature between phones:
When connected to two bluetooth phones, the
phone. To answer a call from the secondary phone
while you are on a call on the primary phone,
please do the following;
1. Press the MFB once and you will be switched
to the secondary phone while the primary
phone goes on stand-by mode.
2. Press the MFB button again to switch back to
your previous phone call with the primary
phone. You may repeat this as needed to switch
back & forth between phones.
7
• Rejecting a call:
Press and hold the MFB for 3
seconds during an incoming call.
• Redialing the last number:
In stand-by mode,
press the MFB twice.
• Adjusting volume:
Press the + and – buttons to
adjust the speaker output volume.
• Mute/Unmute the microphone:
During a call,
press and hold the Mute button for 3 seconds.
Repeat to unmute. When muted, the Bluetooth®
will beep twice every few seconds to indicate it
is muted.
• Transfer a call from N620 to phone:
During
a call, press the + and – buttons simultaneously
for 3 seconds. Repeat this method as needed to
transfer between the phone and the N620.
• Using voice dialing:
If your mobile phone is voice dialing enabled,
press the MFB once and say the voice tag after
you hear a short beep.
Note: You must record voice tags into your
4
