Settings
130
•
Authentication type
—Select
Open
or
Shared
for the
authentication type between your device and the
wireless LAN access point device.
•
WEP key settings
—Enter
WEP encryption
(length of
the key),
WEP key format
(
ASCII
or
Hexadecimal
), and
WEP key
(the WEP key data in the selected format).
Security settings for
802.1x
and
WPA/WPA2
:
•
WPA/WPA2
—Select the means of authentication:
EAP
to use an extensible authentication protocol (EAP)
plug-in, or
Pre-shared key
to use a password.
Complete the appropriate settings:
•
EAP plug-in settings
(only for
EAP
)—Enter the settings
as your service provider instructs.
•
Pre-shared key
(only for
Pre-shared key
)—Enter a
password. The same password must be entered on the
wireless LAN access point device.
•
WPA2 only mode
(only for
WPA/WPA2
)—Select
whether Temporal Key Integrity Protocol (TKIP) is used.
Homepage
—Define a home page.
Select
Options
>
Advanced settings
and from the
following:
IPv4 settings
:
Phone IP address
(the IP address of your
device),
Subnet mask
(the subnet IP address),
Default
gateway
(the gateway), and
DNS address
. Enter the IP
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings
>
DNS address
—Select
Automatic
,
Well-
known
, or
User defined
.
Ad-hoc channel
(only for
Ad-hoc
)—To enter a channel
number (1-11) manually, select
User defined
.
Proxy server address
—Enter the address for the proxy
server.
Proxy port number
—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data connection
—If you select
When available
and you are in a network that supports packet data, the
device registers to the packet data network. Starting an
active packet data connection (for example, to send and
receive e-mail) is quicker. If there is no packet data
coverage, the device periodically tries to establish a packet
data connection. If you select
When needed
, the device
uses a packet data connection only if you start an
application or action that needs it.
Access point
—The access point name is needed to use your
device as a packet data modem to your computer.
High speed packet access
—Enable or disable the use of
HSDPA (network service) in UMTS networks. For more
information on HSDPA, see ‘Fast downloading’, p. 14.
Summary of Contents for 002D2Q8
Page 1: ...Nokia N95 1 ...
