To set the device to silence an incoming call or snooze
an alarm when you tap the device twice, select
Tap to
silence
.
To set the device to silence an incoming call or snooze
an alarm when you turn the device face down, select
Turn to silence
.
Security settings
About security settings
Select
Menu
>
Control panel
>
Settings
and
General
>
Security
.
Define the following security settings:
•
Phone and SIM card
— Adjust the security settings
for your device and SIM card.
•
Certificate management
— Manage your security
certificates.
•
Security module
— Manage your security module.
Avoid using codes that are similar to emergency
numbers to prevent accidental dialling of the
emergency number. Codes are shown as asterisks.
When you change a code, enter the current code, then
the new code twice.
Device and SIM card security
To change the PIN code, select
Phone and SIM card
>
PIN code
. The new code must be 4 to 8 digits long. The
PIN code protects your SIM card against unauthorised
use and is provided with the SIM card. After three
consecutive incorrect PIN code entries, the code is
blocked, and you need to use the PUK code to unblock
it before you can use the SIM card again.
To set the keypad to lock automatically after a defined
period, select
Phone and SIM card
>
Keypad
autolock period
.
To set a time-out after which the device is
automatically locked and can be used only if the correct
lock code is entered, select
Phone and SIM card
>
Phone autolock period
. Enter a number for the time-
out in minutes, or select
None
to set off the autolock
period. When the device is locked, you can still answer
incoming calls, and calls may still be possible to the
official emergency number programmed into your
device.
To set a new lock code, select
Phone and SIM card
>
Lock code
. The preset lock code is 12345. Enter the
current code and then the new code twice. The new
code can be 4-255 characters long. Both alphabets and
digits can be used, and both uppercase and lowercase
alphabets are possible. The device notifies you if the
lock code is not properly formatted.
Restore original settings
To restore the original device settings, select
Menu
>
Control panel
>
Settings
and
General
>
Factory
settings
. To do this, you need your device lock code.
After resetting, the device may take a longer time to
switch on. Documents, contact information, calendar
entries, and files are unaffected.
151
Se
ttings
© 2009 Nokia. All rights reserved.
Summary of Contents for 002J3X4
Page 1: ......