Performing the Initial Hardware Configuration
Nokia 100i Installation Guide
31
Table 3
on page 31 shows how to match pins at the console or serial connector
with output pins on DB9 or DB25 cables you are using with terminal devices
or other appropriate equipment.
Connecting Power and Turning the Power On
The power switch and receptacle for the power cord are located on the back of
the gateway, as shown in
Figure 6
.
The gateway power supply automatically detects the input voltage (120 VAC
[100 to 130] or 240 VAC [200 to 264]) and configures itself appropriately.
Table 3 Pin Assignments for DB9 and DB25 Interface Cables
Console or serial
pin and assignment
DB9 cable-output pin and
assignment
DB25 cable-output pin and
assignment
Shield (FG)
Shield (FG)
1 (FG)
2 (RXD)
3 (TXD)
2 (TXD)
3 (TXD)
2 (RXD)
3 (RXD)
4 (DTR)
6 (DSR)
6 (DSR)
5 (SG)
5 (SG)
7 (SG)
6 (DSR)
4 (DTR)
20 (DTR)
7 (RTS)
8 (CTS)
5 (CTS)
8 (CTS)
7 (RTS)
4 (RTS)
Summary of Contents for 100i
