Installing a Network Interface Card
Nokia 100i Installation Guide
45
7.
Place the screws through the standoff holes on the card and into the
standoffs on the motherboard.
8.
Turn each screw clockwise to attach the card to the standoffs.
Do not tighten completely.
9.
Make sure that all four standoff connections are properly aligned.
10.
To secure the connections, tighten the screws firmly, but do not
overtighten.
11.
Slide the chassis assembly back into the gateway and resecure the two
retaining screws.
Reseating the chassis assembly automatically restores power to the
gateway.
The accelerator card is automatically detected and enabled by default.
Installing a Network Interface Card
All network interface cards (NICs) installed in the Nokia 100i gateway are
installed in the 6U PMC carrier. Ethernet NICs can occupy any of the slots or
subslots in a gateway that other I/O cards do not occupy.
Screw
Accelerator card
Standoff hole
Motherboard standoff
Summary of Contents for 100i
