Navi Bars
GB 20
Maintenance folder
System Information
When you enter the Maintenance folder, you will find general
information about which hardware and software version your
Mediamaster is running on.
Reinstall
Only
use this option if you have to start the complete installation
procedure from scratch. If you continue from here,
all
your previous
settings, access code and favourite channels, etc. will be erased.
If you do not want to reinstall, you can leave this menu when
the warning is displayed by pressing "back".
SW update
Your Mediamaster will advise you from time to time of any new
software upgrades using information sent via the cable network.
This will appear as a message on your TV screen asking you to press
ok
to start the download. You are strongly advised to accept the
download as this might enable you to receive new features and/or
services that may be available to you. You can choose to postpone
the download for a more convenient time by pressing the back
button. The message will appear again provided that the software
is still being broadcast.
NOTE: These messages will only appear if your Mediamaster
has been switched on from Standby.
It is advisable to put your Mediamaster into standby when not in
use.
After downloading a new software version,
all
your previous
settings, access code and favourite channels, etc. will be erased.
NOTE:
It may take a while to complete the update.
NEVER turn off the Mediamaster, never use the remote control or
disconnect the antenna cable during the download procedure as
this will damage the software and the receiver
will have to be
sent in for service.
Message folder
Messages from the Service Provider can be shown in this menu.
