3
Performing the Initial Configuration
44
IP390
, 105i & 105s
Security Platform Installation Guide
If the Hostname? prompt does not appear on the console, check the
console port and console display connections to ensure that the serial
cable is completely plugged in at both ends. If you verify the console
connections and still do not see either the BOOTMGR> or Hostname?
prompts, verify that the terminal or terminal emulator program settings
are correct. If the settings are correct, contact your Nokia service provider
as listed in
“Nokia Contact Information”
on page 3.
3.
Respond to the Hostname? prompt within 30 seconds to prevent the
DHCP client from starting.
If the DHCP client starts, it might configure the appliance with an
incorrect host name and IP address (this could happen if a DHCP server
on your network is configured to respond to any request). To reset the
incorrect host name and IP address:
a.
Establish a console connection to the appliance.
b.
Enter the following:
rm /config/active
or
mv /config/active /config/active.old
c.
Reboot the appliance.
d.
Respond to the Hostname? prompt within 30 seconds to prevent the
DHCP client from restarting.
4.
At each subsequent prompt, type the requested configuration information
and then press Enter.
For more information about how to respond to the prompts during the
initial configuration process, see the
Getting Started Guide and Release
Notes
for the version of Nokia IPSO you are using.
5.
After you complete the initial configuration, you can use Network
Voyager to configure the remaining network ports.
All manuals and user guides at all-guides.com
