Installation procedure
60
Nokia FastMile Outdoor Unit User Manual
3TG-00088-AAAA-TCZZA
Issue: 01P03
Figure 22
Mounting the Nokia FastMile Outdoor Unit
ix
If the Nokia FastMile Outdoor Unit is to be connected to an outside ground, use a hex
key to connect the ground cable to the ground connection point of the Nokia FastMile
Outdoor Unit and ensure that the far end of the ground cable is connected to a suitable
ground point. Figure
shows the location of the ground point on the Nokia FastMile
Outdoor Unit.
x
Pass the Ethernet cable from the Nokia FastMile Outdoor Unit through the hole in the
wall and use silicone or other waterproof sealing or caulking compound to seal the hole.
xi
If required, rotate the Nokia FastMile Outdoor Unit +/-35 degrees horizontally for best
alignment with the LTE base tower. Tighten the fasteners to securely hold the Nokia
FastMile Outdoor Unit in place.
xii
If the Ethernet cable from the Nokia FastMile Outdoor Unit will not be long enough to
reach the indoor unit or PoE injector, make the cable longer by attaching an additional
Cat5e shielded Ethernet cable to it. The maximum combined length is 40 m (131 ft).
Do not run the cable to the indoor unit or PoE injector yet.
xiii
Confirm that the indoor unit that is going to provide service for the Nokia FastMile
Outdoor Unit is installed and powered up, or install and power up the indoor unit. The
indoor unit indoor unit can be a residential gateway such as the Nokia 7368 ISAM CPE
A-020W-A.
27901