Chapter 3: Installing, Monitoring, and Replacing Components
52
IP700 Series Installation Guide
Installing a PCMCIA Modem
The IP700 Series appliance supports a Nokia-approved PCMCIA modem
card that allows you to set the country code through Voyager. For
information about the country codes, see the Voyager Reference Guide.
To use a modem with the IP700 Series appliance, use the following
procedures:
1.
If the modem is not factory installed, insert the Nokia-approved
PCMCIA modem into either the top or bottom PCMCIA slot until the
modem clicks into place.
The modem and the ejector on the left of the slot protrude from the
unit. The appliance automatically recognizes the modem.
2.
Whether or not the modem is factory installed, connect the modem to
a phone line.
Use a cable that is appropriate for the modem and for the telephone
system in the country in which you will use the device.
To access this feature, click Config on the Home page in Voyager and
then click on the Network Access and Services link in the Security
and Access Configuration section.
For information about accessing Voyager and the related reference
materials, see “Using Voyager to Configure the Network Interfaces” on
page 67.
All manuals and user guides at all-guides.com
