Chapter 4: Configuring and Monitoring the IP700 Series Appliance
78
IP700 Series Installation Guide
Entering Initial Interface Information
1.
Select an interface you want to use to access the IP700 Series
appliance from the host that runs your browser. System startup
searches for all of the connected interfaces and displays a list of the
physical IDs that it finds.
A system startup example screen follows:
Select an interface from the following for
configuration:
1)eth-s1p1
2)eth-s1p2
3)ser-s2p1
4)atm-s3p1
5)quit this menu
Enter choice [1-5]:
To select an interface, type the number adjacent to the physical IDs
that appear. Your selection determines the interface you use to access
the IP700 Series appliance for configuration tasks.
NOTE:
A physical ID identifies the network interface card type (
nic-type
)
and provides information about its slot number (
slot-num
) and port
number (
port-num
).
The physical ID syntax is:
nic-type
-s
slot-num
p
port-num
For example, the physical ID of a serial card in slot 1, port 1 would be:
ser-s1p1
Similarly, the physical ID of an Ethernet card connected to port 2 of a
multiport card installed in slot 4 would be:
eth-s4p2
All manuals and user guides at all-guides.com