Chapter 5: Connecting to the Network
88
IP700 Series Installation Guide
across the entire width of the card, while the connector on the back of the
incompatible quad-port Ethernet card runs only halfway across the width
of the card.
Hardware Setup
When you specify that an Ethernet NIC is to be included with your IP700
Series appliance, the board is installed before the appliance is delivered to
you.
Connectors and Cables
The Ethernet connectors on the appliance and on the card are RJ-45. To
connect to a 10-Mbps or 100-Mbps hub, use a straight-through RJ-45
cable. To connect directly to a host, use an RJ-45 crossover cable wired as
the following figure shows.
You can order appropriate adapter cables separately. You can also order
additional cables from a cable vendor of your choice.
All manuals and user guides at all-guides.com
