Nokia Network Voyager for IPSO 4.0 Reference Guide
85
9.
Click Apply.
10.
Enter a number in the Keepalive maximum failures text box.
This value sets the number of times a remote system can fail to send a keepalive protocol
message within a keepalive interval before the systems considers the link down.
11.
Click Apply.
12.
Click the Advanced PPP Options link.
The
PPP Advanced Options
page appears.
13.
Click Yes or No in the Negotiate Magic Number field.
Clicking Yes enables the interface to send a request to negotiate a magic number with a peer.
14.
Click Yes or No in the Negotiate Maximum Receive Unit field.
Clicking Yes enables the interface to send a request to negotiate an MRU with a peer.
15.
Click Apply.
16.
Click Up to return to the
Physical Interface
page.
17.
Click the logical interface name in the Interface column of the Logical Interfaces table to go
to the
Interface
page.
18.
Enter the IP address for the local end of the link in the Local address text box.
19.
Enter the IP address of the remote end of the link in the Remote address text box. Click
Apply.
20.
(Optional) Change the interfaces logical name to a more meaningful name by typing the
preferred name in the Logical name text box.
Click Apply.
21.
(Optional) Add a comment to further define the logical interfaces function in the Comments
text box.
Click Apply.
22.
To make your changes permanent, click Save.
To configure a serial interface for frame relay
1.
Click Interfaces under Configuration > Interface Configuration in the tree view.
2.
Click the physical interface link to configure in the Physical column. Example:
ser-s2p1.
3.
(Optional) Click On or Off in the Physical configuration table Internal Clock field to set the
internal clock on the serial device.
Set the internal clock to On when you are connecting to a device or system that does not
provide a clock source. Otherwise, set the internal clock to Off.
4.
Click Apply.
5.
If you turned the internal clock on, enter a value in the Internal clock speed text box.
If the device can generate only certain line rates, and the configured line rate is not one of
these values, the device selects the next highest available line rate.
Summary of Contents for IPSO 4.0
