9.
Bend the bent lock pin and the area around it to the same level as the side of shield lid. Be very careful that
the shield itself does not bend.
Figure 77 Bending the lock pin and the area around it
10. Slide the shield lid over the shield frame and push it in place for example with your thumb or the back of
a tweezers.
Figure 78 The shield lid in place
11. Ensure that all lock pins are in place and the shield lid is properly attached to the shield frame.
Note:
Make sure that there is no gap between the shield lid and the frame!
RM-42
RF Troubleshooting and Manual Tuning Guide
Nokia Customer Care
9241872 (Issue 1)
Company Confidential
Page 7–59
Copyright ©2005 Nokia. All Rights Reserved.
