Phoenix installation steps in brief
Before you begin
Recommended PC HW requirements:
• Computer processor: Pentium 700 MHz or higher
• RAM 256 MB
• Disk space 100-200 MB
Supported operating systems:
• Windows 2000 Service Pack 3 or higher
• Windows XP Service Pack 1 or higher
Context
Phoenix is the service software for reprogramming, testing and tuning the phone.
Phoenix installation contains:
• Service software support for all phone models included in the package
• Flash update package files for programming devices
• All needed drivers for:
• DK2 dongle
• DKU-2 USB cable
Note:
Separate installation packages for flash update files and drivers are also available, but it is not
necessary to use them unless updates appear between Phoenix service software releases. If separate
update packages are used, they should be used after Phoenix and data packages have been installed.
The phone model specific data package includes all changing product specific data:
• Product software Binary files
• Files for type label printing
• Validation file for the Faultlog repair data reporting system
• All product specific configuration files for Phoenix software components
Note:
Phoenix service SW and phone data packages should only be used as complete installation
packages. Uninstallation should be made from the Windows Control Panel.
To install Phoenix, you need to:
Steps
1. Connect a DK2 dongle to your computer.
2. Install the Phoenix Service SW.
3. Install the phone-specific Data Package for Phoenix.
4. Configure users.
5. Manage connection settings (depends on the tools you are using).
If you use FPS-8:
• Update FPS-8 SW
• Activate FPS-8
RM-42
Service Software Instructions
Nokia Customer Care
9241872 (Issue 1)
Company Confidential
Page 3–5
Copyright ©2005 Nokia. All Rights Reserved.
