Nokta MAKRO EZ Wander, User Manual

1. MAKE SURE YOUR DETECTOR IS OFF!
2. 

Insert your wired headphone's plug into the headphone jack located on the side of the 

EZ Wander. 

3. 

Press and hold down the power button on the EZ Wander for about 7 seconds. The blue 

LED will flash fast while the button is pressed down.  Do not let go of the button until the 

beep indicating the battery status is heard through the headphones and the red LED on 

the EZ Wander lights up. Once the button is released, the blue LED will start blinking every 

2 seconds. EZ Wander is now ready to be paired.

4. 

5Headphones will emit a number of beeps to indicate the battery status as follows: Five 

(5) beeps for fully charged battery, four (4), three (3), two (2) beeps to indicate diminishing 

charge and one (1) beep if the battery is low. In addition, the red LED will blink as many 

times as the beeps (e.g. red LED blinks 5 times with 5 beeps). When the battery is 

approaching full depletion, the headphones will start emitting continuous beeps at short 

intervals indicating an immediate need to charge the battery. 

IMPORTANT! Disconnection 

and unpairing may occur when the battery is low! 
5. 

Turn the detector on while pressing the SETTINGS button and do NOT let go of the 

button until ''HP'' is displayed on the screen.

6. 

When the pairing is successful, the audio will be heard through the headphones and 

the blue LED on the EZ Wander will start blinking about every second. In addition, the 

wireless icon will appear at the bottom right corner of the screen. If the pairing is not 

successful, the wireless icon will start blinking. In such a case, repeat the above steps.

7. 

Once the pairing is successful, if you experience any distortion in the audio or 

interference from another detector, first select WIRELESS from options. Change the 

channel by using the plus (+) and minus (-) button. Each time you press the buttons, 

channels will change between 00-19-oF. At oF position, the wireless connection is off. 

When you are not using the EZ Wander, keeping the WIRELESS setting at oF position 

is recommended.

8. 

Once the pairing is complete, the EZ Wander and the detector will connect automatically 

at the next start-up. To turn on or off the EZ Wander, press and hold the power button for 

about 3 seconds. 

9. 

To adjust the volume, use the VOLUME setting of the detector.

IMPORTANT! FOR OPTIMAL PERFORMANCE, BE SURE THAT THE

EZ WANDER AND THE DETECTOR ARE ON THE SAME SIDE!

 Pairing Instructions for Anfibio and Kruzer