Nokta MAKRO EZ Wander, User Manual

7. 

If the pairing is not successful or if you experience any distortion in the audio or 

interference from another detector, change the channel by pushing and holding the trigger 

switch forward on Racer 2 and Gold Racer while pressing the down button simultaneously 

and  on the Impact, by pulling and holding the trigger switch while pressing the down 

button simultaneously. Each time you press the down button, channels will change 

between 00-09-oF.

8. 

Once the pairing is complete, the EZ Wander and the detector will connect automatically 

at the next start-up. To turn on or off the EZ Wander, press and hold the power button for 

about 3 seconds. 

9. 

To adjust the volume, use the on-off/volume knob on the detector. 

NOTE! 

If the connection is lost during pairing, the blued LED on the EZ Wander will flash 

fast. In such a case, turn off and restart the detector and the EZ Wander and repeat the 

process.
Charge the battery if it is low. 

1. 

You can charge the EZ Wander with a USB charger, a powerbank or on a PC or in your 

car using the included charging cable. The charging time may be longer for USB chargers 

rated less than  1 Amp or older type of PCs.

2. 

Insert one end of the charging cable into the charger and the other end into the charging 

jack on the EZ Wander.

3. 

During charging the red LED will light up.

4. 

Charging will last approximately 2.5 hours.

5. 

Upon completion, the red light will go off.

Charging

Frequency:

 2.4GHz

Battery:

 Lithium Polymer

Battery Runtime:

 Over 16 hours

Charging Time:

 Approximately 2.5 hours

Headphone Input:

 6.3mm (1/4'') jack connector

WxLxH:

 60x61x29,5mm (2.4''x2.4''x1.2'')

Weight:

 81gr. (2.85oz)

Technical Specifications

KKEZW55000366