1
1
3
2
3
2
4
PARTS and ASSEMBLY
1)To attach the telescopic shaft to
the S-rod, first loosen the twist
lock. 2)By holding the metal pin
pressed, insert the telescopic
shaft into the S-rod and click the
pin into its hole. 3)Secure it by
tightening the twist lock. 4)After
adjusting the shaft length to your
height, secure by tightening the
twist lock.
1)Place the washers into the
openings at the end of the
telescopic shaft. 2)Place the shaft
on the coil as shown in the
picture. 3)Secure by tightening
the bolt and the wingnut.
Wrap the coil cable around the
shaft all the way up as shown in
the picture and after inserting it in
the coil input socket underneath
the system box, secure it by
twisting the connector. Pay
attention to not wrap the cable
too tight during this step. Insert
the handle cable in the socket
underneath the system box
(HANDLE) and secure it by
twisting the connector. Finally,
secure the cable by attaching the
clamps at 3 different spots.
FORS / Page 5
www.noktadetectors.com
NOKTA DETECTORS
