4
Copyright Nolan Systems Inc. 2005
info@nolan-sys.com
http://www.nolan-sys.com/
This material may not in whole or part be copied, or communicated to third parties without Nolan Systems prior agreement in
writing.
Nolan Systems – USA
1595 Cleo Springs Dr.
San Jose, Ca. 95131, USA
Tel: 408-392-0928 Fax: 408-392-0998
Charging the Headset
Before using the headset, you must charge the headset for a minimum of two hours. When
fully charged, the battery provides up to 8 hours of talk time and up to 150 hours of standby
time.
To charge the headset
1.
Plug AC Adapter into headset charge socket (refer to
Fig 1)
.
The Amber LED will be
illuminated when the headset is charging.
2.
After charging finished, the Amber LED will be off. Unplug the AC adapter from the
charge socket.
Battery Status indication:
The Amber LED will remain illuminated while the headset
battery is charging. When the battery is fully charged, Amber LED will be off.
Turn on / off the Headset
To turn on the headset
With the headset turned off, press and hold the Talk button for 3 seconds. You will
hear an “ON” tone (
two ascending “beeps”
) and the blue LED will quick flash 5
times. The headset turns on and is placed in standby mode, ready to make and receive
calls. After turn on the headset, the headset will try to connect the last
paired/connected device automatically.
To turn off the headset
With the headset turned on, press and hold the Talk button for 3 seconds. You will
hear an “OFF” tone (
two descending “beeps”
) and after the amber LED quick flash 5
times, the headset is turned off. Then release the Talk button.
Pair the Headset with Bluetooth enabled devices
Pairing is the process of linking the headset with your Bluetooth mobile phone.
Before you use the headset with your mobile phone, you must pair both devices. After
pairing is completed, you can use the headset only with the paired mobile phone. If
you wish to use the headset with a different mobile phone, you must redo the pairing
process with the new mobile phone. In this case, the headset will no longer work with
the previous mobile phone.
Before you commence pairing the headset, ensure that the battery is fully charged.
To pair the device
1.
With the headset turned off, press and hold the Talk button for 5 seconds. You
will hear a “PAIR” tone and the LED quick flash 5 times and the two LED
flash alternatively to indicate the headset entered into pairing mode.
2.
Release the Talk button. The headset is now in “Pairing” Mode.
3.
Turn on the mobile phone and place it within 10 feet of the headset.
4.
Initiate the device discovery feature on the mobile phone. Refer to the mobile
phone user guide for instructions for initiating this feature.
5.
When prompted by the mobile phone, enter the headset pin code “
0000
”. And
the Blue LEDs will quick flash 5 times to indicate pairing finished. Now the
headset is placed in standby mode, ready to make and receive calls.
