START-S5PV
Technical manual
-8-
2.3 Connection of the TENSION
230 Vac
1 2 3
Connection of the TENSION. It can be two ways of powering the control unit:
The power supply of the control unit should be protected from a magnet-switch or from a couple of 5A fuses.
A differential switch is suggested if it is already available in the installation.
1 2 3
400 Vac
2.4 Connection of the LAMP
ON
CTS
2
1
4
3
6
5
8
7
10
9
ON
CTS
2
1
4
3
6
5
8
7
10
9
4 5 6 7 8 9 10 11
230 Vac
DIP 7 ON
In case the lamp without
flashing light card.
DIP 7 OFF
In case the lamp has a
flashing light control card.
2.5 Connection of a 24V light for working and opening gate
12 13 14 15 16
30 31
Terminal board 14-15
Power supply of the accessories
Tension:
24Vac
Maximum current:
300mA
2.6 Connection of a CONTACTOR
4
6
5
6
Open Contactor
Close contactor
4 5 6
Pay attention not to invert the poles OPEN and
CLOSE.
In case of doubts put manually the gate in the
middle.
Be ready to stop the gate with STOP control.To
make sure of the opening and closing try to interrupt
the photo-beams, if the gate closes it means that
the connection is not correct and you need to invert
the cables of the motor OPEN AND CLOSE.
