Replace the fuse.
USER SERVICING INSTRUCTIONS
A) Light set fuse replacement (replaceable 3 A, 125 V fuses)
B) Extension cord fuse replacement (1 replaceable 5 A, 125 V fuse is located in the plug):
Note: This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do not use with an extension
cord unless plug can be fully inserted. Do not alter or replace the plug.
Replace the lamp.
OPEN
OPEN
a) Before using or reusing, inspect product carefully. Discard any products that have cut, damaged,
or frayed wire insulation or cords, cracks in the bulb holders or enclosures, loose connections,
b) When storing the product, carefully remove the product from wherever it is placed to avoid any
or exposed copper wire.
Use and care instructions
undue strain or stress on the product conductors, connections, and wires.
If the bulb base of the replacement bulb does not fit in the string: (as shown below by the Figs.)
a) Pull the reflector out.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Unlock the burned out LED bulb by lifting the hook.
4. Replace bulb with only 3.0 Volt, 20 mA push-in type LED bulb (provided with product). Always
5. Lock the hook of bulb base by pushing lock down into the tab.
3. Pull bulb and plastic base straight out of bulb holder.
match the hook to the tab.
Hook
Tab
Unlock
Lock
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
3. Remove fuse carefully.
4. Risk of fire. Replace fuse only with 3 Amp, 125 Volt fuse (provided with product).
should not be removed. Discard product if the attachment plug is damaged.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
3. Remove fuse carefully.
4. Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse.
should not be removed. Discard product if the attachment plug is damaged.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that
CAUTION:
1. To reduce the risk of overheating, replace burned-out bulbs promptly. Use
Volt,
3.0
20 mA LED bulbs only. The LED lbulb has polarity. Do not deliberately change the direction of the LED
Caution
e) Insert the reflector into the base.
b) Remove the base of burned-out bulb by straightening bulb leads and gently pull bulb out.
c) Thread wires of new bulb through holes in old base with one wire in each hole.
d) After bulb is fully inserted into base, bend each wire up, like other bulbs
in the light set so that the wires will touch the contacts inside the
bulb holder (always match the long wire of new bulb to the hook of
bulb base).
bulb in the bulb holder. 2. Risk of fire. This product does not contain bulb shunts, which allow the
product to operate if one bulb burns out. Replace bulbs only with the spare bulbs provided with this
product.
