AG 2100 Quick Start (cont’d)
| Page 3 of 10 |
Note: The AG 2100 must be connected to a live network that can access the Internet
or it will not be able to receive the License Key from Nomadix as explained in step 3
below.
3.
Connect the power cord to turn on the AG 2100. You can also use PoE to power the AG
2100
4.
Configure the Laptop with the following parameters:
a.
For network side configuration of NSE:
IP: 172.30.30.173
Subnet: 255.255.0.0
Gateway: 172.30.30.172
b.
For subscriber side configuration of NSE:
Any IP address configuration is acceptable.
Wireless Configuration:
SSID: Nomadix
Security:
Open
5.
Wait for the AG 2100 to finish initializing (which is when the power light starts blinking)
and start a Telnet session to communicate with the AG 2100 using the default
management IP address: 172.30.30.172
Note: The AG 2100 may take up to 5 minutes to power up for the first time as it
looks for DHCP server
6.
Log in to the Command Line interface:
Note: The default for both the Username and Password is admin
.
7.
Go to the “Configuration” section on the next page and configure the AG 2100 for your
network.
