If you did not get the correct measurement, you can delete all the
results by following steps below .
Deleting the Records
1. Press and hold the M button
for 3 seconds when the
monitor is in the memory
recall mode, the display
will show a flashing
“dEL ALL”.
2. Press the S button to
confirm deleting and
the monitor will display
“dEL dOnE” and then
turn off.
3. If there are no records,
when you press the M
button, This display will
show "---".
START
STOP
Note: To exit out of delete mode
without deleting any records,
press the START/STOP button
before pressing the S button
to confirm any delete commands.
12
DATA MANAGEMENT
Summary of Contents for NOTMB1491
Page 2: ...Table of Contents...
Page 26: ...Innholdsfortegnelse...
Page 50: ...Sis llysluettelo...
Page 74: ...Indholdsfortegnelse...
