____________________________________________________________________________________
____________________________________________________________________________________
Speeder X1 and X2 Configuration and API Guide
Page 9/36
2 OPERATION MODES
2.1 List of operation modes
0
ASCII mode / Configuration Mode (Chapter 3.1)
The Sensor sends measurement results in ASCII format according to the
user’s
commands and parameter settings. In this mode the sensor receives commands like
parameter change and state control or operation mode selection.
1
Continuous ASCII mode (Chapter 3.1)
The sensor sends measurement results in ASCII format continuously according to the
parameter settings.
5
Trigger window mode (Chapter 5.1)
The sensor controls the measurement results in the trigger window, and according to
parameters it gives trigger-output-signal and sends trigger distance to serial-port. In this
mode the Speeder sensor operates with one laser for accurate detection.
7
Speed measurement mode for vertical installation (Chapter 4.1)
The sensor waits for the target to be in the trigger window and then starts measuring the
change of distance to the target in the selected windows. Speeder X1 comprises two
integrated laser transmitters with a small angle, allowing measurement of two
consecutive overlapping speed profiles from the vehicle.
12
Speed measurement mode for horizontal installation (Chapter 0)
The mode is designed to be used from the side of the road at the level of vehicles. The
mode gives possibility to catch speed of vehicles travelling on one or multiple lanes.
