4
3.2
Sensor Installation without an Existing Severe Terrain Option
1.
Install the brackets as shown in
Section 6
.
2.
Install the sensors (E07) into the brackets with the lower serial number on the left (
Figure
4
and
Figure 5
).
3.
The outer wing sensors will have been installed with either a 2-way coupler with terminator
(NORAC part number 43764T [E20]) or a 3-way coupler and a terminator plug (NORAC
part numbers 43760 and 43764 [E10 & E20]). Determine which type is installed and follow
the appropriate set of instructions.
3.2.1
Installation with 2-Way Coupler with Terminator
1.
Remove the 2-way coupler with terminator (E20) from the outer sensor and install it at the
inner sensor.
2.
Install the 3-way coupler (E10) at the outer sensor. Plug the existing CANbus cable (C05)
and the sensor cable into the 3-way coupler.
3.
Connect the CANbus cable (C06) between the 2-way coupler with terminator (E20) and
the 3-way coupler (E10).
Components shown in black are included in this kit.
Components shown in green are included in the bracket and hardware kit.
Components shown in blue are existing components.
Figure 6: Electrical Installation: 2-Way Coupler with Terminator
