9
4.3
Main Lift Sensor Installation
1.
There are a variety of ways to mount the main lift bracket. The bracket should position the
sensor approximately in the center of the sprayer, forward of the boom. An example of
this mounting is illustrated in
Figure 8
.
2.
Mount the ultrasonic sensor to the main lift bracket.
Figure 8: Example Mounting of the Main Lift Sensor
Avoid mounting the main lift sensor over or near a wheel-track. Measurements
from the wheel-track do not provide an accurate crop height and will cause
measurement and control error.
Ensure the bracket does not collide with any other part of the sprayer throughout
the full range of main lift motion.
Summary of Contents for UC5 Rogator 600
