SECTION 3
"
Routine Care and Maintenance
3-6
6200 Hand-Held Computer
Hand Strap Replacement
If the hand strap shows obvious signs of wear or breaks, it should be re-
placed. To replace it follow these steps.
1. Open the bottom knob latch (in the direction of the arrow on the
case) with a coin or flat blade screwdriver. Refer to Figure 3-3 on
page 3-7 for help with these steps. Use a flat blade screwdriver or
the edge of a coin, to open the door. Use a screwdriver or coin that
fits the slot properly or in time it will wear away the corners of the
latch knob.
2. Slide the hand strap off of the battery compartment. This end stays
with the hand strap. You will install the whole piece with your new
hand strap.
Summary of Contents for 6200
Page 1: ...6200 Hand Held Computer USER S GUIDE NPN 961 028 075 Revision A June 1995 ...
Page 38: ...SECTION 2 Hand Held Computer Operation 2 14 6200 Hand Held Computer ...
Page 52: ...SECTION 4 Troubleshooting 4 4 6200 Hand Held Computer ...
Page 56: ...SECTION 5 Connector Pin Outs 5 4 6200 Hand Held Computer ...