PPC-3315E
6
Chapter Three Hardware Installation
Before installing the computer accessories
Following the instructions below will help to prevent your computer from being damaged,
and also ensuring your personal safety.
1
:
Please make sure your computer is disconnected from the power supply.
2
:
Please always wear anti-static strap or gloves to operate the board in case that you may
touch the integrated circuit components, such as RAM.
3.1 Jumper Settings
Please refer to following instructions to do jumper settings before installing your hardware
devices.
Remark:
How to identify the PIN1 of all jumpers and interfaces: Please observe the word
mark on the side of the plug socket, which will be a “1” or bold line or triangular symbol; And
please look at the back of PCB, each with a square shape will be the PIN 1; and all the jumpers’
PIN1 have a white arrow on the side.
3.1.1 Jumper Settings
(
JP1
,
J12, J13, J14
)
JP1 is used to set the start-up mode of the motherboard, insert the jump cap to download
mode, and unplug it to normal start-up mode;J12 is used to set the power supply of LVDS
screen, which can be set according to different screens, and J13 is used to set the 12V
power supply.
Summary of Contents for PPC-3315E
