Owner’s Manual 12
Fault Codes
Corrective Actions
Check:
- That the refrigerator is ON.
- That the battery charging equipment of the vehicle is operational.
- The the AC/DC converter is operational (if applicable).
- See your dealer or authorized Norcold Service Center.
Check:
- That the valve of the propane gas tank(s) is open.
- That the propane gas is at the correct pressure.
- That the manual shut off valve of the refrigerator is open.
- That there is no air in the propane gas supply line. See “Removing air
from the propane gas supply lines” section of this manual.
Check:
- That the refrigerator is plugged into a serviceable outlet.
- That the fuse or circuit breaker is intact.
- That the vehicle generator is operational (if applicable).
- See your dealer or authorized Norcold Service Center.
Check:
- That the battery charging equipment of the vehicle is operational.
- The the AC/DC converter is operational (if applicable).
- See your dealer or authorized Norcold Service Center.
1st time - Before reset
Check:
- That the vents are not blocked.
- That a door(s) is not open. Close door(s).
- That the vehicle is level.
2nd time - After reset.
This is not owner serviceable. See your dealer or authorized Norcold Service
Center.
This is not owner serviceable. See your dealer or authorized Norcold Service
Center.
This is not owner serviceable. See your dealer or authorized Norcold Service
Center.
This is not owner serviceable. See your dealer or authorized Norcold Service
Center.
This is not owner serviceable. See your dealer or authorized Norcold Service
Center.
Fault Code Meaning
DC voltage is
unavailable to
the refrigerator
control panel or the
refrigerator is OFF.
The burner did not
ignite or re-ignite.
AC voltage is
unavailable to the
refrigerator control.
DC voltage to the
refrigerator control
panel is too low.
The refrigerator cooling
unit has stopped
cooling.
The refrigerator is
operating on the “Back
Up Operating System”.
This is a fault within the
refrigerator controls.
This is a fault within the
refrigerator controls.
This is a fault within the
refrigerator controls.
Fault Code
No display.
“F”
“A”
“C”
“n”
Temperature setting
flashes for ten seconds
and mode appears.
“H”
“r”
“S”
