BC 60 "Trailblazer" Brushcutter
PRE-OPERATION
DEC/2012 (49458202/8203)
Section 2-5
Figure 3A. Front Console
ENGINE DIAGNOSTIC GAUGE
(Upper Portion of Console)
Turn the ignition switch to the first detent (power will come on, but engine is not started) and wait.
The Powerview will come on, and a “WAIT TO START-PREHEAT” message will appear on the screen. A light (Wait
to Start) directly beneath the Powerview will turn on.
When the message disappears and the light goes out, it is safe to start the engine.
Instrument or Control
Type of Control
Functional Description
Menu Key
The Menu Key is touched to either enter or exit the
menu screens.
The
Menu
key is only used during factory setup
procedures. (See Component Data Section for
additional operation and setup instructions.)
Left Arrow
Use the
left to move to the left or upward in a 4-Up
screen.
You can use the left arrow at any time to
return to the previous screen.
Right Arrow
Use the right arrow key to move to the right or
downward in a 4-Up screen, or to move to the next set
of 4 controls.
Enter Key
The enter key is used when a fault occurs.
Generally, any fault that occurs will come up on the
screen at the time it happens. In order to go back
to the original status screen you have to push the
enter key once. NOTE: This will hide the fault
screen until you 1) correct the fault, or 2) you press
enter again.
Summary of Contents for Trailblazer BC60
Page 2: ......
Page 48: ...BC 60 Trailblazer Brushcutter MAINTENANCE AUGUST 2012 49458202 8203 Section 3 3...
Page 49: ...MAINTENANCE BC 60 Trailblazer Brushcutter Section 3 4 AUGUST 2012 49458202 8203...
Page 64: ...BC 60 Trailblazer Brushcutter MAINTENANCE MARCH 2011 49458201 Section 3 21 TORQUE REQUIREMENTS...
