Assembly Steps
3. Install the steering shaft.
4. Install the steering wheel .
5. Connect the power supply.
Turn the vehicle on its side.
Insert the straight end of steering
shaft through the hole in the vehicle
body and out through the hole in the
dashboard.
Insert the bent end into the hole in
the front axle.(PIC1)
As showed in the picture, remove the
nut and bolt from the steering wheel,
connect the steering wheel and
gauge board middle connector.
As showed in the picture, install the
steering wheel, and fasten with nut
and bolt.
.
Plug the power connector into the
terminal on battery as shown.
