GB
6. Install the seat and seat back.
After the power supply is installation, put the
seat (part 8) into the assigned location of the car
body, and fix it with the screw (part 16).
Put the seat backrest (part 9) into the assigned
location of the car body as shown in the figure,
and tighten it with the seat backrest screw (part
16).
Install the windshield (part 2) at the specified
position on the front of the car. Before the
installation, fix the position of each buckle and
press until it is fastened.
Insert the rear wing (part 10) at the direction
shown by the arrow, and insert the
corresponding buckle, and press the buckle
firmly until it is fasten
7. Install the windshield and the empennage
