User Guide
P. 3
Caution:
do not
turn the key to the
CRANK
position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the start kill / anti-
grind feature (optional).
Idle Mode
This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
IGNITION
switch. The vehicle will keep running for the pre-
programmed run time, or until it is shut down by remote.
Caution:
Do not leave children or pets unattended in a car running in idle mode.
To activate Idle Mode:
To enable idle mode, press and hold the
LOCK
,
UNLOCK
or
START/STOP
button on your remote
transmitter while the engine is running.
Note:
When enabling idle mode, pressing
LOCK
or
UNLOCK
will automatically unlock the
doors.
The parking lights will come on. Remove the key, exit the vehicle and lock the doors (if
desired). The engine will continue running and will turn itself off when the pre-programmed
run time expires.
Valet Mode
Ignition Valet
The system can be placed in valet mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, valet mode will prevent the engine from
being accidentally started by remote control.
To ENTER Valet Mode
1.
With the key in the ignition switch, turn the key to the ON
(RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2.
The parking light will flash 3 times indicating the module is now in valet mode. The
LED will turn
ON
solid.
To EXIT Valet Mode
1.
With the key in the ignition switch, turn the key to the ON
(RUN/IGNITION)
and then
OFF positions 5 times within 10 seconds.
2.
The parking light will flash twice indicating the module is now out of valet mode.
The led will turn OFF.
Valet Mode Using the Valet Button
(Available only of the plug-in valet switch is installed)
To put the system
into
valet mode:
1.
Turn the key to the
IGNITION ON (RUN)
position.
2.
Press (for at least 1 second) and release the valet button.
The L.E.D. will come ON.
To take the system
out of
valet mode:
1.
Turn the key to the
IGNITION ON (RUN)
position.
2.
Press (for at least 1 second) and release the valet button. The L.E.D. will go OUT.
The valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN)
position.
