Introduction
This module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user’s expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.
Basic Remote Operation
Your remote car starter can operate two independent vehicles equipped with an identical
remote car starter (see multi-car operation on page 6).
The functions of the transmitter are as follows:
Pressing the
LOCK
and
UNLOCK
buttons simultaneously will activate the
AUX 2
output.
Remote-starting Your Vehicle
Press the
START/STOP
button for approx. 1 second. The parking lights will come
ON
, informing
you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The
parking lights will remain
ON
during the pre-programmed run time.
If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.
Vehicle Presets
Heater and Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on
HIGH
. It is recommended to leave the settings
on
LOW
or
MEDIUM
instead.
Windshield Wipers, Radio and Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are off. Leaving the headlight switch
ON
on certain types of vehicles could cause them to remain on
even after the remote starter
shuts down, resulting in a dead battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to
DISARM
and
UNLOCK
the doors (if installed). Enter the vehicle and do the following:
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
•
Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
P. 2
User Guide
NS-1014
