Nordic Start NS-1014, User Manual

NS-1014

 User Guide 

P. 3

Caution: do not turn the key to the 

CRANK

 position with the engine running. This will cause 

the starter motor to re-engage, unless your vehicle is equipped with the start kill / anti-
grind feature (optional). 

Idle Mode 

This feature allows the user to engage the remote starter to take over the vehicle while it is 

already running with the key in the 

IGNITION 

switch. The vehicle will keep running for the pre-

programmed run time, or until it is shut down by remote. 

Caution: Do not leave children or pets unattended in a car running in idle mode. 

To activate Idle Mode: 

To enable idle mode, press and hold the 

LOCK

, 

UNLOCK

 or 

START/STOP

 button on your remote 

transmitter while the engine is running.  
Note:  When enabling idle mode, pressing 

LOCK

 or 

UNLOCK 

will automatically unlock the 

doors. 

The parking lights will come on. Remove the key, exit the vehicle and lock the doors (if 
desired). The engine will continue running and will turn itself off when the pre-programmed 

run time expires. 

Valet Mode 

Ignition Valet 

The system can be placed in valet mode to disable the remote starting capabilities. If the 

vehicle needs to be serviced, or if you park it indoors, valet mode will prevent the engine from 

being accidentally started by remote control. 

To ENTER Valet Mode 

1.

With the key in the ignition switch, turn the key to the ON 

(RUN/IGNITION) 

and then 

OFF positions 5 times within 10 seconds. 

2.

The parking light will flash 3 times indicating the module is now in valet mode.  The 

LED will turn

 ON 

solid. 

To EXIT Valet Mode 

1.

With the key in the ignition switch, turn the key to the ON

 (RUN/IGNITION) 

and then 

OFF positions 5 times within 10 seconds. 

2.

The parking light will flash twice indicating the module is now out of valet mode.  

The led will turn OFF. 

Valet Mode Using the Valet Button 

(Available only of the plug-in valet switch is installed)  

To put the system into valet mode: 

1.

Turn the key to the 

IGNITION ON (RUN)

 position. 

2.

Press (for at least 1 second) and release the valet button.  

The L.E.D. will come ON. 

To take the system out of valet mode: 

1.

Turn the key to the 

IGNITION ON (RUN)

 position. 

2.

Press (for at least 1 second) and release the valet button. The L.E.D. will go OUT. 

The valet button can only be used if the vehicle keys are in the 

IGNITION ON (RUN)

 position.