background image

 

DOC: 3.00   

August 29, 2005 

DS CA 

Manufactured in Canada by Autostart 

A U T O M A T I C  

T R A N S M I S S I O N   M U L T I - C H A N N E L   R E M O T E   S T A R T E R   S Y S T E M  

NS-1024HF 

User Guide 

 

Introduction ....................................................... 2

 

Basic Remote Operation................................... 2

 

Remote-starting Your Vehicle........................... 2

 

Vehicle Presets............................................. 2

 

Driving Off..................................................... 2

 

Idle Mode ...................................................... 3

 

Valet Mode........................................................ 3

 

Ignition Valet................................................. 3

 

Valet Mode Using the Valet Button............... 3

 

Panic Mode................................................... 4

 

Cold Weather Mode...................................... 4

 

Advanced Features........................................... 4

 

Remote Door Locks...................................... 4

 

Priority Door Access..................................... 5

 

Arming the Starter Kill................................... 5

 

Installer-programmable Features...................... 5

 

Remote Door Locks Option .......................... 5

 

Ignition-controlled Door Locks Option .......... 5

 

Secure Lock Option...................................... 6

 

Remote Trunk Release Option..................... 6

 

Engine Run Time.......................................... 6

 

Starter Kill / Anti-Grind.................................. 6

 

Multi-car Operation....................................... 6

 

Troubleshooting Poor Transmitting Range Issues

.......................................................................... 6

 

 

INDUSTRY CANADA USER NOTICE: 

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) 
this device must accept any interference, including interference that may cause undesired operation of 
the device. To reduce potential radio interference to other users, the antenna type and its gain should 
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for 
successful communication". 

FCC USER NOTICE (U.S.A.): 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation.  

NOTE: 

The manufacturer is not responsible for any radio or TV interference caused by unauthorized 

modifications to this equipment. Such modifications could void the user's authority to operate the 
equipment.  

Summary of Contents for NS-1024HF








Reviews: