11
NORDIC
If the fasteners remained jammed after following th e above instructions, slightly loosen the four hex screws
upon the nosepiece with an allen key, take off the nose cover then remove the fammed fastener pieces.
Remove the jammed nails with pliers if necessary. After the firing chamer is clear of jams re-tighten the
nose piece with hex screws securely.
Keep opening the magazine, insert the battery and fire two or three
times while empty.
Then reload the staples/nails, close the magazine and resume nomal
operation.
Warning: TO PREVENT SERIOUS INJURY,
grip the tool firmly in both hands.
• Rougly, the hardness of wood is divided into 3 levels:
- High
- Medium
- Low
• Nails of different length are applicable for different wood hardness
• The tool has a recoil when firing, so two hands operation is. suggested to have a better control of the operation.
9. CLEANING AND MAINTENANCE
Always disconnect the plug from the socket before carrying out any cleaning work.
9.1 CLEANING
• Keep all air gaps and engine housing clean as far as possible.
• Wipe the device with a clean cloth or blow it with compressed air.
• We recommend cleaning the device every time it’s done.
