P. 12
User
Guide
NTW-2000
If swap start mode is selected, to remote-start your vehicle, press the
SHIFT
button and then the
LOCK
button. The
AUX 2
output can be activated by pressing the
START/STOP
button.
Home Valet
TM
If this feature is installed, the user will have the possibility to remotely set the vehicle to a no-
remote-start mode. See home valet section, on page 9, for full instructions.
Ignition-Controlled Door Locks
This is an added security feature. If your remote starter was installed with the ignition-controlled
door locks option, the doors will automatically be locked as soon as the ignition key is turned to the
IGNITION ON (RUN)
position while the brakes are pressed. When the key is turned to the
OFF
position,
the doors will automatically be unlocked.
Ignition Re-lock
On remote starters of this series, when ignition-controlled door locks are enabled and the ignition
key is in the
IGNITION ON (RUN)
position, should any door be unlocked and opened, all doors will be
relocked next time the brake pedal is pressed.
Secure Lock
Before it can remote-start your vehicle, the remote starter must first disarm the factory security
system. The secure lock feature may be required on certain vehicle models with factory security
systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
secure lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, secure lock will rearm your factory security system.
Turbo Mode
When left in turbo mode, the remote starter will keep the engine running for 60 seconds before
shutting it down. This is to allow a turbocharger to idle down after the user leaves the vehicle. See
Turbo Mode section on page 8.
Remote Trunk Release
If your system was installed with the remote trunk release option, you can open your trunk by
pressing the
TRUNK
button. There will be one beep and LED #4 will flash 3 times.
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 4, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 9, 20, or 30 minutes (20 minutes default).
Extended Run Time
While the vehicle is running under a remote start, pressing and holding the
START/STOP
button
for more than 3 seconds will reset the run time counter to zero and restart the run time cycle from
the beginning. There will be one beep
a pause
three more beeps; the parking lights will flash
three times and the horn (if configured) will honk once. The extended run time procedure can
only be carried out once per remote start.
To stop the vehicle, at any moment, simply press the
START/STOP
button.
Example: If your remote car starter is programmed for a run time of 4 minutes and your vehicle
has been running for 3 minutes already, pressing the
START/STOP
button will reset the
counter to zero and allow the engine to run for another cycle (in this case, 4 minutes).
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same remote starter model, to
control both systems with a single remote control. To control the second vehicle, simultaneously
press the
TRUNK
button and the button of the function you wish to use.
Note: Your remote control must be configured for second car operation by the installer.
