NTW-2000
Guide d’installation
P. 9
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec., press the valet button (the L.E.D. will come
ON
solid).
3.
The parking lights will flash three times to indicate that the vehicle is now in valet mode. The
L.E.D. will come
ON
solid.
To take the system o u t o f valet mode:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec., press and release the valet button (the L.E.D. will come
OUT
).
3.
The parking lights will flash twice to indicate that the vehicle is now in valet mode.
The L.E.D. will go out.
Note: Once valet mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
This feature will allow you to remotely put your system into valet mode by using the ignition key
instead of the valet button as above. Ignition valet can be used without a valet button installed.
To put the system i n t o valet mode:
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into
the
IGNITION ON / RUN
and
OFF
positions.
The parking lights will flash three times to indicate that the vehicle is now in valet mode. The L.E.D.
will come
ON
solid.
To take the system o u t o f valet mode:
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into
the
IGNITION ON / RUN
and
OFF
positions.
The parking lights will flash twice to indicate that the vehicle is now in valet mode. The L.E.D. will
go out.
Note: With the remote valet activated, the remote starter and alarm functions will be disabled.
Remote Valet Mode
This feature will allow you to remotely put your system into valet mode by using the transmitter
instead of the valet button as above.
Getting into valet mode
•
Hold the
UNLOCK
and
START/STOP
buttons simultaneously for 3 second.
•
The parking lights will flash 3 times.
The LED will remain on solid.
Getting out of valet mode
•
Hold the
UNLOCK
and
START/STOP
buttons simultaneously for 3 second.
•
The parking lights will flash 2 times.
The LED will turn off.
“Home Valet
TM
” Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the home valet mode is activated, the vehicle will not start by remote.
To take the system i n t o home valet mode:
•
Press the
LOCK
or
UNLOCK
button.
•
Within 3 seconds, press the
LOCK
and
START/STOP
buttons simultaneously until the
parking lights go out
To take the system o u t o f home valet mode:
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
