CUCINOTTA
– CUCINOTTA
Forno
26
7093101 – EN
In presence of dampness in the room where the cooker has been placed, we advise you to put absorbent
salts into the hearth.
If you want to keep for long the aesthetic look of the cooker it is important to protect its internal walls in row
cast iron with neutral Vaseline.
16. CONNECTING A CHIMNEY OR OPEN FURNACE TO THE FLUE
The smoke channel is the section of tube that connects the product to the flue, in the connection these
simple but very important principles must be followed:
•
for no reason must the smoke channel be used with a diameter lower than that of the neck of the
outlet with which the product is fitted;
•
each metre of horizontal route of the smoke channel causes a small leak of charge which should be
compensated for by raising the flue;
•
the horizontal section must never be higher than 2 m (UNI 10683-2005);
•
each bend of the smoke channel considerably reduces the draught of the flue which must be
compensated for by raising it suitably;
•
the UNI 10683-2005 Regulation –Italy requires that the bends or variations of direction must in no
case be greater than 2 including the emission into the flue.
Wanting to use the flue of a chimney or open furnace, it will be necessary to close the hood hermetically
below the inlet point of the smoke channel pos.
A
Picture 10.
If the flue is too large (e.g. cm 30x40 or 40x50) it is necessary to duct it with a stainless steel tube of at
least 200 mm of diameter, pos.
B
taking care to close the space between the tube itself and the flue
immediately below the chimney cap pos.
C
.
For any further information, please contact your Dealer!
Picture 10
C
- Plugging
A
– Hermetic
closure
Inspection
hatch
B
