DORIS
7193750 Rev.03 – EN
17
The one-piece ceramic glass of the door (resistant up to 700 °C) allows a wonderful view on the burnin g flames.
Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth grate there is an extractable ash drawer, (Picture 8 pos. A).
The heating of the environment is made by irradiation: through the panoramic glass and the external hot surfaces of
the stove, the heat is radiated into the environment.
The stove is equipped with controls of primary and secondary air by which it is adjusted the combustion air.
1A - PRIMARY AIR register (left lever)
Below the hearth door, on the front left side, there is the primary air register, in
the style of lever (Picture 1 - 1A)
With this air register, it is adjusted the passage of primary air into the low part of
the stove and through particular channels flows in the fuel direction. The primary
air is necessary for the combustion process during lighting. The ash drawer
must be regularly emptied, so that the ash does not obstruct the entry of the
primary air for the combustion.
In order to open the air flow, the bar must be completely pulled out.
During wood combustion, the register of primary air must be opened only for a
while, because otherwise the wood burns too fast and the stove may overheat.
2A - SECONDARY AIR register (right lever)
Below the hearth door, on the right front side there is the secondary air register
(Picture 1 - 2A).
The secondary air, passing through the two lateral jambs of the front side, heats
itself starting the double combustion and keeping at the same time the glass
clean (with open register).
When the bar is pushed to the back the passage of the secondary is completely open (Picture 1 - 2A).
3.
RULES FOR INSTALLATION
The stove before being connected with a junction to the chimney of the house, must be assembled and REQUIRES
to be fixed to a non flammable wall as described in Chapter 16. (See chap.4 FIRE SAFETY MEASURES)
The junction must be possibly short, straight, horizontal or positioned a little uphill. The connections must be tight.
It is OBLIGATORY to respect the National and European rules, local regulations concerning building matter
and also fireproof rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular attention to
windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for the
connection must correspond at least to the diameter of the smokes pipe. The opening should be equipped with a wall
connection for the reception of the exhaust pipe and a rose window.
Before installation, check that the capacity of the sub-structure supports the weight of your appliance. If the capacity is
insufficient, it is necessary to take appropriate measures (e.g. plate for the distribution of the weight).
La NORDICA S.p.A. responsibility is limited to the supply of the appliance. Your plant has to be carried out in
compliance with the state of the art, according to the provisions of these instructions and good professional
practice, by qualified personnel, acting for companies authorized to acquire the whole responsibility for the
whole plant.
LA NORDICA is not responsible in case of modification of the product and for the use of not original spare
parts. The hearths must not be modified.
THE HEARTHS MUST NOT BE MODIFIED.
4.
FIRE SAFETY MEASURES
The following safety measures must be complied with when installing the stove:
a)
the minimum distance from the rear and both sides from construction and inflammable objects and objects
sensitive to heat (furniture, wooden coverings, textiles etc.), must be that indicated on the technical data plate
fixed to the product (Picture 2 A) in order to ensure sufficient heat insulation.
All the minimum safety distances
are shown on the product data plate and lower values must not be used.
b) there must be no objects or materials that are inflammable or sensitive to heat in front of the hearth door, in its
radiation area, at a distance less than 100cm. This distance can be reduced to 40 cm when a back-ventilated
and heat-resistant protection is installed in front of the entire component to be protected.
c)
If the product is installed on a non totally refractory floor, one must foresee a fireproof background. The floors
made of inflammable material, such as moquette, parquet or cork etc., must be replaced by a layer of no-
Picture 1
2A
1A
Summary of Contents for Doris Bianco Infinity
Page 48: ...DORIS 48 7193750 Rev 03 IT EN DE FR 16 MONTAGGIO ASSEMBLY MONTAGE 1 2 41x 2x 4x 2x 2x ...
Page 49: ...DORIS 7193750 Rev 03 IT EN DE FR 49 3 4 298 298 ...
Page 50: ...DORIS 50 7193750 Rev 03 IT EN DE FR 6 5 7 9 8 ...
Page 51: ...DORIS 7193750 Rev 03 IT EN DE FR 51 Dx IMPORTANT 10Silk VOGUE 7 x 7 x Sx IMPORTANT ...
