7
2. Attach four Base Pads (99) to the base of the Uprights
(69) with four 1” Screws (148). Note: One replacement
Base Pad may be included. Use the Base Pad to replace
any Base Pad that becomes worn.
With the help of a second person, carefully tip the
treadmill down so the four Base Pads (99) and the Frame
(not shown) are flat on the floor and the Uprights (69) are
in a vertical position.
148
148
148
69
148
99
99
3. With the help of a second person, carefully tip the
Uprights (69) down to the floor as shown.
Orient one of the Wheels (95) as shown, and insert it into
one of the Wheel Endcaps (101). Next, press the Wheel
Endcap and the Wheel into the base of the Uprights (69).
Attach the Wheel Endcap and the Wheel with two Wheel
Bolts (94) and two Nuts (9).
Do not overtighten the
Wheel Bolts; the Wheels should turn freely.
Attach the other Wheel (95) and Wheel Endcap (101) as
described above.
With the help of a second person, carefully raise the
Uprights (69) to the vertical position.
9
95
101
69
94
94
95
4. Cut the tie securing the Pulse Wire (66) to the Uprights
(69). Hold the Pulse Bar Assembly (65) near the crossbar
on the Uprights. Connect the Pulse Wire to the wire in the
Pulse Bar Assembly.
The connectors should slide to-
gether easily and snap into place. If they do not, turn
one connector and try again.
Insert the wires into the
crossbar.
Attach the Pulse Bar Assembly (65) to the crossbar on the
Uprights (69) with four Pulse Bar Bolts (33) and four Star
Washers (77).
Start all four Pulse Bar Bolts and then
tighten them. Make sure that no wires are pinched.
69
66
33
33
65
77
77
66
101
2
3
4
9
