NordicTrack 1500i Treadmill, User Manual

8

8.

Make sure that all parts are properly tightened before you use the treadmill.

Keep the included allen

wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 27). 

To protect the

floor or carpet from damage, place a mat under the treadmill.

6. Set the console assembly on the Uprights (69). 

Make sure

that no wires are pinched. Finger tighten

a Console Bolt

(78) with a Star Washer (77) into the lower hole in each
Upright (only one side is shown).

Next, 

finger tighten

a Short Console Bolt (106) with a

Star Washer (77) into the upper hole in each Upright (69)
(only one side is shown). 

Be careful not to drop the

Short Console Bolts into the Uprights.

Firmly tighten

the two Console Bolts (78) and the two Short Console
Bolts.

Insert an Upright Endcap (79) into the top of each Upright
(69) (only one side is shown). Note: Insert the end of the
Upright Endcap indicated by the arrow first; use a rubber
mallet if necessary. 

106

69

77

77

78

Console 

Assembly

79

7. Press the Latch Knob Sleeve (70) into the left Upright (69).

Note: It may be helpful to use a rubber mallet to fully insert
the Latch Knob Sleeve.

Remove the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. 

Note: If there

are two collars, place one on each side of the spring.

Insert the pin into the Latch Knob Sleeve (70) and the left
Upright (69).  

Tighten the knob back onto the pin.

69

70

Knob

Pin

Collar

Spring

5. Have a second person hold the console assembly near the

Uprights (69). Connect the Upright Wire Harness (98) and
the Pulse Wire (66) to the wires extending from the console
assembly. 

The connectors should slide together easily

and snap into place. If they do not, turn one connector
and try again.

Then, insert the connectors into the console

assembly. 

Connect the Upright Ground Wire (11) to the ground wire
extending from the console assembly. 

Make sure that

the wires are fully connected.

Then, insert the ground

wires into the console assembly.

69

98

Console 

Assembly

Ground

Wire

66

11

98

66

5

6

7