7
2. Orient the Front Stabilizer (3) as shown.
While a second person lifts the front of the
Frame (1), attach the Front Stabilizer (3) with
two M10 x 120mm Screws (100).
2
3
1
100
3. Identify and orient the Upright (5) and the Top
Cover (23) as shown.
Slide the Top Cover (23) upward onto the
Upright (5).
Have a second person hold the Upright (5) and
the Top Cover (23) near the Frame (1).
Locate the wire tie in the Upright (5). Tie the
lower end of the wire tie to the Upright Wire (60).
Next, pull the upper end of the wire tie until the
Upright Wire is routed through the Upright.
Tip: To prevent the Upright Wire (60) from
falling into the Upright (5), secure the Upright
Wire with the wire tie.
Tip: Avoid pinching the Upright Wire (60).
Slide the Upright (5) onto the Frame (1).
Attach the Upright (5) with eight M8 x 16mm
Screws (102) and eight M8 Split Washers (131)
(only four of each are shown);
do not tighten
the Screws yet.
Do not press the Top Cover (23) into place
yet.
3
5
Wire Tie
Wire Tie
23
60
102
102
102
131
131
131
1
Avoid pinching the
Upright Wire (60)
Summary of Contents for 23897.0
Page 33: ...33 NOTES ...
